OMC INTAKE SYSTEMS

NOW CARB OZZ FOR ONE BARRELS AND TWO BARRELS

OMC OZZ FRONTHALF WITH 2 BARREL INTAKES

OMC BOLT ON EFI

OMC OZZ FRONT HALF WITH F1 STYLE INTAKE

OZZ FRONT HALVES ONLY PRICES

OZZ-V4             $1400.00

OZZ-V6             $1650.00

                                                        OZZ-V8             $1600.00 special order only not in stock  

 

CUSTOM REED BLOCKS FOR OZZ FRONT, WITH REEDS      $125.00 each

INTAKE MANIFOLDS FOR ONE BARRELS OR OMC CARBS $40.00 EACH

REPLACEMENT REEDS          $120.00 V6 

THIS SYSTEM CAN CHECK
OUT YOUR INTERNAL PARTS!
RPMS ARE INSTANT!!!

LIST OF PARTS IN SYSTEMS
 

  BOLT ON EFI KIT

                                4, 6, or 8 cyl. intakes. Complete with brass butterflies, injector bosses, and all linkage hardware.

                                4,6,or 8 Bosch high flow injectors with clip on wire harness and G. M. Weather Pack connectors.

                                T-6 billet fuel rails

                                Digital ECU and injector driver with programmer (no software needed)

                                Large fuel pump , pressure regulator and filter

                                Throttle position sensor, Hall effect crank position sensors , water and air temp sensors

 

                                                                                                               OZZ EFI KIT

 

                                NEW FRONT HALF, 2 barrel intakes, T-6 billet fuel rails

                                Starter bracket (OMC crossflow V6 starter)

                                custom reed blocks with phenolic reeds

 

CARB SET UP FOR OMC LOOPER

OMC OZZ V8 ................................$2850.00
OMC OZZ V6 .................................$2550.00
OMC OZZ V4 .................................$2200.00

These are front half's with the reed blocks, reeds, intake manifolds, linkage and starter bracket for crossflow starter

It takes a lot of time to make and test all the parts on this web page. If you run an OMC and you want to out run a $16000.00 to $18000.00 Dollar Mercury you will have to have something different than jetting you carbs and cutting your heads and making bigger ports. If you do out run them it won't last long on carbs, EFI just works better.

Spend some money on a good motor and you will not regret it, give it what it wants

AIR!!!